01、回音降噪 echo_cancellation

02、自動增益控制 auto_gain_control

03、噪聲抑制 noise_suppression

04、 高通濾波器 highpass_filter

05、立體聲交換 stereo_swapping

06、NetEq容量 audio_jitter_buffer_max_packets

07、NetEq快速模式 audio_jitter_buffer_fast_accelerate

08、jitter buffer最小延遲 audio_jitter_buffer_min_delay_ms

09、itter buffer是否適應延遲重傳 audio_jitter_buffer_enable_rtx_handling

10、鍵盤檢測 typing_detection

11、殘留回聲檢測 residual_echo_detector

12、音頻網絡適配器 audio_network_adaptor_config

// 設置音頻參數 bool WebRtcVoiceEngine::ApplyOptions(const AudioOptions& options_in) {RTC_DCHECK_RUN_ON(&worker_thread_checker_);RTC_LOG(LS_INFO) << "WebRtcVoiceEngine::ApplyOptions: "<< options_in.ToString();AudioOptions options = options_in; // 選項在下面進行了修改// 設置和調整回聲消除器選項。不使用硬件 AEC 時，默認使用桌面 AEC。bool use_mobile_software_aec = false;#if defined(WEBRTC_IOS)if (options.ios_force_software_aec_HACK &&*options.ios_force_software_aec_HACK) {// 在ios上強制軟件回聲消除options.echo_cancellation = true;RTC_LOG(LS_WARNING)<< "Force software AEC on iOS. May conflict with platform AEC.";} else {// 默認使用VPIO內置的回聲消除options.echo_cancellation = false;RTC_LOG(LS_INFO) << "Always disable AEC on iOS. Use built-in instead.";} #elif defined(WEBRTC_ANDROID)use_mobile_software_aec = true; #endif// Android 的噪聲抑制選項 #if defined(WEBRTC_ANDROID)options.typing_detection = false;options.experimental_ns = false; #endif// 設置和調整增益控制選項. #if defined(WEBRTC_IOS)// iOS平臺使用VIPIO內置的降噪。options.auto_gain_control = false;options.experimental_agc = false;RTC_LOG(LS_INFO) << "Always disable AGC on iOS. Use built-in instead."; #elif defined(WEBRTC_ANDROID)// Android平臺關閉試驗性AGC.options.experimental_agc = false; #endif#if defined(WEBRTC_IOS) || defined(WEBRTC_ANDROID)// 移動端(ios android)// 如果設置了"WebRTC-Audio-MinimizeResamplingOnMobile"則關閉AGC。// 然后如果開啟降噪且未開啟回聲消除則關閉高通濾波器。。// (https://bugs.chromium.org/p/webrtc/issues/detail?id=6181).if (minimized_remsampling_on_mobile_trial_enabled_) {options.auto_gain_control = false;RTC_LOG(LS_INFO) << "Disable AGC according to field trial.";if (!(options.noise_suppression.value_or(false) ||options.echo_cancellation.value_or(false))) {// If possible, turn off the high-pass filter.RTC_LOG(LS_INFO)<< "Disable high-pass filter in response to field trial.";options.highpass_filter = false;}} #endifif (options.echo_cancellation) {// 目前只有android支持內置aec// 如果支持內置aec而且開啟回聲消除echo_cancellation和未開啟use_delay_agnostic_aec// 且內置EnableBuiltInAEC時關閉軟件回聲消除從而使用平臺內置回聲消除。const bool built_in_aec = adm()->BuiltInAECIsAvailable();// 除了Android平臺為true，其他平臺默認為falseif (built_in_aec) {// 此設備上存在內置 EC。 根據 echo_cancellation 音頻選項啟用/禁用它const bool enable_built_in_aec = *options.echo_cancellation;if (adm()->EnableBuiltInAEC(enable_built_in_aec) == 0 &&enable_built_in_aec) {// 如果啟用內置 EC，則禁用內部軟件 EC，即將軟件 EC 替換為內置 ECoptions.echo_cancellation = false;RTC_LOG(LS_INFO)<< "Disabling EC since built-in EC will be used instead";}}}// 判斷是否支持平臺內置agc,如果支持則關閉軟件agcif (options.auto_gain_control) {bool built_in_agc_avaliable = adm()->BuiltInAGCIsAvailable();if (built_in_agc_avaliable) {if (adm()->EnableBuiltInAGC(*options.auto_gain_control) == 0 &&*options.auto_gain_control) {// 如果啟用了內置 AGC，則禁用內部軟件 AGC，即將軟件 AGC 替換為內置 AGCoptions.auto_gain_control = false;RTC_LOG(LS_INFO)<< "Disabling AGC since built-in AGC will be used instead";}}}// 如果支持平臺內置降噪則關閉軟件降噪if (options.noise_suppression) {if (adm()->BuiltInNSIsAvailable()) {bool builtin_ns = *options.noise_suppression;if (adm()->EnableBuiltInNS(builtin_ns) == 0 && builtin_ns) {// 如果啟用了內置 NS，則禁用內部軟件 NS// 即用內置 NS 替換軟件 NSoptions.noise_suppression = false;RTC_LOG(LS_INFO)<< "Disabling NS since built-in NS will be used instead";}}}// 立體聲通道交換if (options.stereo_swapping) {RTC_LOG(LS_INFO) << "Stereo swapping enabled? " << *options.stereo_swapping;audio_state()->SetStereoChannelSwapping(*options.stereo_swapping);}// jitter buffer最大包數設置if (options.audio_jitter_buffer_max_packets) {RTC_LOG(LS_INFO) << "NetEq capacity is "<< *options.audio_jitter_buffer_max_packets;audio_jitter_buffer_max_packets_ =std::max(20, *options.audio_jitter_buffer_max_packets);}// jitter buffer加速設置if (options.audio_jitter_buffer_fast_accelerate) {RTC_LOG(LS_INFO) << "NetEq fast mode? "<< *options.audio_jitter_buffer_fast_accelerate;audio_jitter_buffer_fast_accelerate_ =*options.audio_jitter_buffer_fast_accelerate;}// jitter buffer最小延遲（毫秒）if (options.audio_jitter_buffer_min_delay_ms) {RTC_LOG(LS_INFO) << "NetEq minimum delay is "<< *options.audio_jitter_buffer_min_delay_ms;audio_jitter_buffer_min_delay_ms_ =*options.audio_jitter_buffer_min_delay_ms;}if (options.audio_jitter_buffer_enable_rtx_handling) {RTC_LOG(LS_INFO) << "NetEq handle reordered packets? "<< *options.audio_jitter_buffer_enable_rtx_handling;audio_jitter_buffer_enable_rtx_handling_ =*options.audio_jitter_buffer_enable_rtx_handling;}webrtc::AudioProcessing* ap = apm();if (!ap) {RTC_LOG(LS_INFO)<< "No audio processing module present. No software-provided effects ""(AEC, NS, AGC, ...) are activated";return true;}if (options.experimental_ns) {experimental_ns_ = options.experimental_ns;}webrtc::AudioProcessing::Config apm_config = ap->GetConfig();#if !(defined(WEBRTC_ANDROID) || defined(WEBRTC_IOS))if (experimental_ns_.has_value()) {apm_config.transient_suppression.enabled = experimental_ns_.value();} #endifif (options.echo_cancellation) {apm_config.echo_canceller.enabled = *options.echo_cancellation;apm_config.echo_canceller.mobile_mode = use_mobile_software_aec;}if (options.auto_gain_control) {const bool enabled = *options.auto_gain_control;apm_config.gain_controller1.enabled = enabled; #if defined(WEBRTC_IOS) || defined(WEBRTC_ANDROID)apm_config.gain_controller1.mode =apm_config.gain_controller1.kFixedDigital; #elseapm_config.gain_controller1.mode =apm_config.gain_controller1.kAdaptiveAnalog; #endif}if (options.tx_agc_target_dbov) {apm_config.gain_controller1.target_level_dbfs = *options.tx_agc_target_dbov;}if (options.tx_agc_digital_compression_gain) {apm_config.gain_controller1.compression_gain_db =*options.tx_agc_digital_compression_gain;}if (options.tx_agc_limiter) {apm_config.gain_controller1.enable_limiter = *options.tx_agc_limiter;}if (options.highpass_filter) {apm_config.high_pass_filter.enabled = *options.highpass_filter;}// 殘留回聲檢測if (options.residual_echo_detector) {apm_config.residual_echo_detector.enabled = *options.residual_echo_detector;}if (options.noise_suppression) {const bool enabled = *options.noise_suppression;apm_config.noise_suppression.enabled = enabled;apm_config.noise_suppression.level =webrtc::AudioProcessing::Config::NoiseSuppression::Level::kHigh;RTC_LOG(LS_INFO) << "NS set to " << enabled;}// 鍵盤聲音檢測if (options.typing_detection) {RTC_LOG(LS_INFO) << "Typing detection is enabled? "<< *options.typing_detection;apm_config.voice_detection.enabled = *options.typing_detection;}ap->ApplyConfig(apm_config);return true; }

總結

以上是生活随笔為你收集整理的AudioOptions的全部內容，希望文章能夠幫你解決所遇到的問題。

如果覺得生活随笔網站內容還不錯，歡迎將生活随笔推薦給好友。