因此，我最近購買了一臺Dell Perc H310 RAID控制器，放入運行Ubuntu Server 18.04.1 LTS的Fujitsu Esprimo P700 E85 +計算機中。主板似乎沒有UEFI，只有BIOS。從硬件角度看，我：

將500GB引導驅動器直接連接到MoBo

通過SATA至mini-SAS電纜分配器將2 * 3TB SATA驅動器連接到RAID控制器

在引導配置BIOS中配置了Raid0，RAID1虛擬驅動器

并且在控制器的菜單中一切似乎都很好。

但是當我啟動Ubuntu(安裝在Boot HDD上)時，找不到6TB，3TB RAID驅動器(分別為RAID0和1)，也沒有它組成的2 * 3TB單獨驅動器。

I used parted --list and lsblk to check for the drive(s) and lspci to check the controller.

The ouput of lsblk is:

NAME MAJ:MIN RM SIZE RO TYPE MOUNTPOINT

loop0 7:0 0 87.9M 1 loop /snap/core/5328

loop1 7:1 0 86.6M 1 loop /snap/core/4486

sda 8:0 0 465.8G 0 disk

├─sda1 8:1 0 1M 0 part

└─sda2 8:2 0 465.8G 0 part /

The output of parted --list is:

Model: ATA WDC WD5000AAKX-0 (scsi)

Disk /dev/sda: 500GB

Sector size (logical/physical): 512B/512B

Partition Table: gpt

Disk Flags:

Number Start End Size File system Name Flags

1 1049kB 2097kB 1049kB bios_grub

2 2097kB 500GB 500GB ext4

The output of lspci is:

00:00.0 Host bridge: Intel Corporation 2nd Generation Core Processor Family DRAM Controller (rev 09)

00:01.0 PCI bridge: Intel Corporation Xeon E3-1200/2nd Generation Core Processor Family PCI Express Root Port (rev 09)

00:02.0 VGA compatible controller: Intel Corporation 2nd Generation Core Processor Family Integrated Graphics Controller (rev 09)

00:16.0 Communication controller: Intel Corporation 6 Series/C200 Series Chipset Family MEI Controller #1 (rev 04)

00:16.2 IDE interface: Intel Corporation 6 Series/C200 Series Chipset Family IDE-r Controller (rev 04)

00:16.3 Serial controller: Intel Corporation 6 Series/C200 Series Chipset Family KT Controller (rev 04)

00:19.0 Ethernet controller: Intel Corporation 82579V Gigabit Network Connection (rev 04)

00:1a.0 USB controller: Intel Corporation 6 Series/C200 Series Chipset Family USB Enhanced Host Controller #2 (rev 04)

00:1b.0 Audio device: Intel Corporation 6 Series/C200 Series Chipset Family High Definition Audio Controller (rev 04)

00:1d.0 USB controller: Intel Corporation 6 Series/C200 Series Chipset Family USB Enhanced Host Controller #1 (rev 04)

00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev a4)

00:1f.0 ISA bridge: Intel Corporation Q65 Express Chipset Family LPC Controller (rev 04)

00:1f.2 SATA controller: Intel Corporation 6 Series/C200 Series Chipset Family SATA AHCI Controller (rev 04)

00:1f.3 SMBus: Intel Corporation 6 Series/C200 Series Chipset Family SMBus Controller (rev 04)

01:00.0 RAID bus controller: LSI Logic / Symbios Logic MegaRAID SAS 2008 [Falcon] (rev 03)

And the output of lspci -vv for the RAID controller is:

01:00.0 RAID bus controller: LSI Logic / Symbios Logic MegaRAID SAS 2008 [Falcon] (rev 03)

Subsystem: Dell MegaRAID SAS 2008 [Falcon]

Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-

Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- SERR-

Interrupt: pin A routed to IRQ 16

Region 0: I/O ports at e000 [size=256]

Region 1: Memory at fe460000 (64-bit, non-prefetchable) [size=16K]

Region 3: Memory at fe400000 (64-bit, non-prefetchable) [size=256K]

Expansion ROM at fe440000 [disabled] [size=128K]

Capabilities:

Kernel modules: megaraid_sas

注意：我還在帶有UEFI的Windows計算機上嘗試了RAID Ctrlr。在我通過PCIe通道B5和B6進行錄音之前(我在網上某個地方找到了這個建議)，它沒有用卡進行POST。之后，它可以識別RAID0配置。將卡和磁盤移回Ubuntu系統并在那里啟動也沒有成功。控制器的行為與以前完全相同，這就是為什么我尚未在兩條通道上都移除磁帶。

我應該如何進行？

總結

以上是生活随笔為你收集整理的计算机丢失KTcontroller,无法识别Dell Perc H310 RAID控制器上的RAID驱动器的全部內容，希望文章能夠幫你解決所遇到的問題。

如果覺得生活随笔網站內容還不錯，歡迎將生活随笔推薦給好友。