cisco 两个设备之间测试吞吐量的一个方法
兩個cisco AIR-BR1310G-A-K9-R設備，測試其之間可以達到的吞吐量。
一邊ping包，
WJ-Bridge-D2#ping 10.10.192.10 repeat 3000 time 0 si 9000
Type escape sequence to abort.
Sending 3000, 9000-byte ICMP Echos to 10.10.192.10, timeout is 0 seconds:
......................................................................
......................................................................
......................................................................
......................................................................
......................................................................
另一邊過幾秒查看一次，當達到最高時，就是近似它的吞吐量了。
D2-Bridge-WJ#sh int dot11Radio 0
Dot11Radio0 is up, line protocol is up
Hardware is 802.11G Radio, address is 0007.0e7d.2370 (bia 0007.0e7d.2370)
MTU 1500 bytes, BW 54000 Kbit, DLY 1000 usec,
reliability 238/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/1127/0/0 (size/max/drops/flushes); Total output drops: 23115
Queueing strategy: fifo
Output queue: 0/30 (size/max)
30 second input rate 44000 bits/sec, 60 packets/sec
30 second output rate 59000 bits/sec, 60 packets/sec
609068 packets input, 127665404 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
727710 packets output, 737221567 bytes, 0 underruns
37745 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
D2-Bridge-WJ#
轉載于:https://blog.51cto.com/cisco130/1221584
總結
以上是生活随笔為你收集整理的cisco 两个设备之间测试吞吐量的一个方法的全部?jī)?nèi)容，希望文章能夠幫你解決所遇到的問題。
- 上一篇： java swing 组件技术(上)
- 下一篇： 日常检查IBM P系列小型机状态的项目及