問題

My application is able to connect to the BLE peripheral(which is an OBDII/J1939 device) device successfully.

2018-01-24 14:58:38,413 INFO LogUtil - GATT Server Status = (0) : BLE_HCI_STATUS_CODE_SUCCESS(0x00)

2018-01-24 14:58:38,414 INFO LogUtil - GATT Server New State = (2) : STATE_CONNECTED

2018-01-24 14:58:38,414 INFO LogUtil - Connected to GATT server.

Application started communication with the device but after some time it received GATT server disconnection message in onConnectionStateChange in callback implementation of BluetoothGattCallback . Below are the logs from application:

2018-01-24 15:07:46,396 INFO LogUtil - GATT Server Status = (40) : BLE_HCI_INSTANT_PASSED(0x28)

2018-01-24 15:07:46,397 INFO LogUtil - GATT Server New State = (0) : STATE_DISCONNECTED

2018-01-24 15:07:46,398 INFO LogUtil - Disconnected from GATT server.

Not able to find any reason behind BLE_HCI_INSTANT_PASSED status code.

Any help on this will be helpful.

回答1:

When data is being transmitted over BLE, data transfers can only start at sync points in time known as "connection events". At the BLE link layer there are couple special requests that can be made which are relative to these sync points. They are:

LL_CHANNEL_MAP_REQ - A request to change the BLE channels being transmitted on. Bluetooth chips will change the channel map based on the noise in the environment to try to limit packet drop.

LL_CONNECTION_UPDATE_REQ - A request to change the frequency of "connection events" (known as the "connection interval"). This is done to achieve better throughput/latency or save more power.

Each of these Link Layer requests when sent over the air contains an "Instant" to change. The "Instant" is the "connection event" in the future to apply the change.

At the Link Layer, BLE is reliable. This means each Link Layer packet must be ack'd by the other side. In a noisy RF environment, it's possible a link layer packet may require a couple retries to actually send. This means the packet could arrive many "connection events" after originally intended.

If one of the packets mentioned above is received after the "Instant" the changes were supposed to be applied, by definition the BLE chip must disconnect with reason 0x28 (Instant Passed)

For additional details on the topic, the Bluetooth Core Specification available from the Bluetooth SIG website is a good reference:

來源：https://stackoverflow.com/questions/48447645/android-ble-peripheral-disconnects-with-status-code-ble-hci-instant-passed0x28

總結

以上是生活随笔為你收集整理的android ble status,Android BLE peripheral disconnects with status code BLE_HCI_INSTANT_PASSED(0x28)的全部內容，希望文章能夠幫你解決所遇到的問題。

如果覺得生活随笔網站內容還不錯，歡迎將生活随笔推薦給好友。